Bosch GTM 12 Professional - Technical Data; Noise;Vibration Information; Declaration of Conformity; Assembly and Transport

56 | English
1 609 929 U05 | (9.6.09) Bosch Power Tools
Technical Data
Noise/Vibration Information
Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98.5 dB(A);
Sound power level 111.5 dB(A). Uncertainty
K=3dB.
Wear hearing protection!
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 01.06.2007
Assembly and Transport
f Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Carefully remove all parts provided from their
packaging.
Remove all packing material from the power tool
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Combination saw with pre-mounted saw
blade
– Allen key/slotted screwdriver 5
– Dust bag 8
Additionally for table saw:
– Parallel guide 63
– Hold-down stick 64
– Lower saw blade cover 68
Combination Saw GTM 12
Professional
Article number
3 601 M15 ...
... 0.. ... 060
Rated power
input
W 1800 1650
Rated voltage
V230110
Frequency
Hz 50/60 50/60
No-load speed
min
-1
4300 4300
Laser type
650 nm,
< 1mW
650 nm,
< 1mW
Laser class
2 2
Weight according
to
EPTA-Procedure
01/2003
kg 22.5 22.5
Protection class /II /II
Permissible workpiece dimensions (maximal/minimal):
Chop/mitre saw, see page 62
Table saw, see page 67
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
mm 300–305
Blade thickness
mm 1.5–2.5
Mounting hole diameter
mm 30
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-302-005.book Page 56 Tuesday, June 9, 2009 2:19 PM