17
1 609 929 820 • TMS • 14.02.00
Hand Protector (Optional extra)
For work with the rubber sanding plate 14 or with
the cup brush 17/disc brush/flap disc, mounting
the hand protector 13 (optional extra) is recom-
mended. The hand protector 13 is fastened with
the auxiliary handle 4.
■ Before any work on the machine itself, pull
the mains plug.
Use only grinding tools with a permissi-
ble speed at least as high as the no-load
speed of the machine.
Roughing and cutting discs become very hot
while working; do not touch until they have
cooled.
■ Clean the grinder spindle and all parts to be
mounted. For clamping and loosening the
grinding tools, lock the grinder spindle 7 with
the spindle locking button 5.
Actuate the spindle locking button 5 only
when the grinder spindle is at a standstill!
Roughing/Cutting Disk
The hole of the roughing/cutting disk must fit on
the centring shoulder of the mounting flange 9
without play. Do not use reducer pieces or adapt-
ers.
When using a diamond cutting disk, take care that
the direction of rotation arrow on the diamond cut-
ting disk and the direction of rotation of the ma-
chine (direction of rotation arrow on the machine
head) agree.
For mounting, see the illustration page.
Screw on the clamping nut 11 and tighten with the
two-hole spanner (see Section “Quick Clamping
Nut”).
An O-ring (plastic
part) is inserted in
the retainer flange 9
around the spigot.
If the O-ring is missing or is damaged, it must
in all cases be replaced (Order No.
1 600 210 039) before the retainer flange 9 is
mounted.
☞
After mounting the grinding tool and be-
fore switching on, check that the grind-
ing tool is correctly mounted and that it
can turn freely.
Flap disc
Remove the protective guard 8 and mount the
hand protector 13. Place the special retainer
flange 9 (optional extra, Order No.
2 605 703 028) and the flap disc on the grinder
spindle 7. Screw on the clamping nut 11 and
tighten with the two-hole spanner.
Rubber Sanding Plate 14
Remove the protective guard 8 and mount the
hand protector 13.
For mounting, see the illustration page.
Screw on the round nut 16 and tighten with the
two-hole spanner.
Cup Brush 17/Disc brush
Remove the protective guard 8 and mount the
hand protector 13.
The grinding tool must be able to be screwed onto
the grinding spindle 7 until it rests firmly against
the grinder spindle flange at the end of the grinder
spindle threads. Tighten with an open-ended
spanner.
All grinding tools described in these operating in-
structions can be used (roughing and cutting
discs of synthetic resin-bonded, fibre-reinforced
material).
The permissible speed [RPM] or the circumferen-
tial speed [m/s] of the grinding tools used must be
at least in accordance with the values given in the
table.
Therefore, always observe the permissible rota-
tional/circumferential speed on the label of the
grinding tool.
Mounting the Grinding Tools
(Optional Accessories)
9
Approved Grinding Tools
max.
[mm] [mm]
Db d [min
-1
] [m/s]
115
125
6
6
22.2
22.2
11 000
11 000
80
80
125 – – 11 000 80
75 30 M 14 11 000 45
b
d
D
D
D
b
d
To Next Page
Loading...
