ASIEN • Printed in Germany • BA 1 609 929 C74 • GWS 21/24/26 • OSW 09/01
English - 2
1
Thread for auxiliary handle (3x)
2
Spindle locking button
3
On/Off switch
4
Auxiliary handle
5
Grinding spindle
6
Protective hood
7
Adjustment screw
8
Clamping lever
9
Retainer mounting flange with O-ring
10
Roughing/cutting disc*
11
Clamping nut
12
Quick clamping nut*
13
Clamping screw
14
Coded projection
15
Protective hood for grinding cup*
16
Grinding cup*
17
Hand protector*
18
Spacing disc*
19
Rubber sanding plate*
20
Sanding sheet*
21
Round nut*
22
Cup brush*
23
Diamond cutting disc*
24
Cutting guide with protective vacuuming
hood*
25
Handle unlocking button
26
Handle
27
Cutting grinder stand*
*Optional Extras
*
Not all the illustrated or described accessories are in-
cluded as standard delivery.
Working safely with this ma-
chine is possible only when the
operating and safety information
is read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served. Before using for the first
time, ask for a practical demon-
stration.
If the cable is damaged or cut
through while working, do not touch
the cable and pull the plug immedi-
ately. Never use the machine with a
damaged cable.
Wear protective glasses and ear
protection.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suit-
able dust-/chip extraction and wear
a dust mask.
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of ma-
terials are particularly dangerous.
Wear protective gloves and sturdy
shoes.
When necessary, also ware an
apron.
■
Connect machines used outdoors via a resid-
ual current device (RCD) with a maximum trig-
gering current of 30 mA. Use only extension
cables that are intended for outdoor use.
■
When working with the machine, always hold it
firmly with both hands and make sure you are
in a secure standing position.
■
Always direct the cable to the rear away from
the machine.
■
Always switch off the machine and allow it to
come to a stop before putting it down.
■
Insert the power plug only when the machine
is switched off.
■
In case of mains failure or when the main plug
is pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
■
The machine should only be used only for dry
cutting/grinding.
■
For all work done with the machine, the auxil-
iary handle
4
must be mounted.
Operating Controls
For Your Safety
GWS 21/24/26 (C74) - Buch Seite 2 Mittwoch, 17. Oktober 2001 11:21 11
7 • 1 609 929 C74 • TMS • 02.08.01
To Next Page
Loading...
