12
3.Reclose the attachment levers (picture C). Close the oven
door.
: Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Dismantling
1.Unhook the oven door and place it on a cloth with its handle
pointing downwards.
2.Remove the upper cover from the oven door. To do this,
press with your fingers on the tabs on the left and right
(Figure A).
3.Lift and remove the top glass panel (Figure B).
In doors with three glass panels, the following step will also be
necessary:
4.Lift and remove the glass panel (Figure C).
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers or hard metal scourers as these could damage the
glass.
: Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Installing
Follow steps 2 to 4 with doors that have two glass panels.
When installing, ensure that the "right above" inscription on the
lower left part is inverted.
1.Insert the glass panel by tilting it backwards (Figure A).
2.Insert the upper glass panel on both mounts by tilting it
backwards. Ensure that its smooth surface is facing
outwards. (Figure B)
3.Fit and tighten the cover.
4.Refit the oven door.
Once the glass panels have been correctly fitted, the oven is
ready to use.
%
$
To Next Page
Loading...
Need help?
General
