Bosch HBL5451UC - Service and Repair; Doors; Removing and Reinstalling the Door

58300000202181 ARA EN B November 2018 Service Manual for Bosch 500 Series Built-in Wall Ovens
Page 13 of 41
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copying, disclosure, or distribution in any format is prohibited.
6 SERVICE AND REPAIR
6.1 Doors
The serviceable parts of the door assembly include the handle,
endcaps, outer door glass/skin (service assembly), two spring hinges,
2-pane glass pack, porcelain-coated door liner, and the various
fasteners.
On double ovens, the Bosch logo is located on the upper oven door
skin.
6.1.1 Removing and Reinstalling the Door
To remove the door…
1. Open door completely.
2. Flip right and left hinge levers back to open, as shown below;
be sure the levers are in the fully open position.
3. Partially close the oven door until it is open about 7”; you will
feel the door catch on the hinge-stop levers.
4. Using both hands, lift door upward and outward to disengage
the hinges from the hinge receiver slots.
5. Set the door aside on a protected flat surface.
To reinstall the door…
1. Hold the door firmly in both hands and position the hinges in
the hinge receivers, so that the slot in the base of the hinge (A)
engages with the hinge receiver (B).
 CAUTION
Avoid injury when removing and replacing oven doors.
 Be sure oven is cool enough for handling.
 Position hinges properly (see Figure 6).
 Grasp only by sides, not by the handle.
 Do not force door open or closed.
 Handle with care–the door weighs approximately 40 lb.
 CAUTION
 Sheet metal parts often have sharp edges. Avoid injury by
handling these parts with care.

Turn off the electrical power circuit to the oven at the main junction
box before servicing this unit.
 For those checks requiring the use of electrical power, exercise
extreme care.
 NOTICE
It may be necessary to use a tool, such as a screwdriver, to gently
pry the upper part of the lever away from the housing. Take care to
avoid scratching the porcelain.
Figure 6 Opening the hinge lever