58300000202181 ARA EN B November 2018 Service Manual for Bosch 500 Series Built-in Wall Ovens
Page 23 of 41
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copying, disclosure, or distribution in any format is prohibited.
6.8 Bake Element
The 240V 2400W bake element is concealed in the base of the oven.
Access to the rear of the unit is necessary when replacing the
element.
Refer to the Element Strip Diagram section to test the bake element at
the control module. A Bake Element Relay Test is also available in
Service mode. See the Service Mode section for additional
information.
If the wires are disconnected from the element terminals, an
ohmmeter can be used to check for resistance of ~24 ohms.
6.8.1 Replacing the Bake Element
1. Remove the screws securing the right and left side trim pieces
to the cabinetry.
2. Carefully slide the oven out of the cutout to gain access to the
bake element from the rear of the unit.
3. Disconnect the wires from the element terminals.
4. Remove the screws securing the bake element access panel.
5. Bend the access panel downward to expose the element.
6. Holding the terminal plate, pull the bake element outward,
leaving the insulation in place; a putty knife or similar tool may
be useful.
6.9 Temperature Sensor
The PT1000 temperature sensor is in the upper left corner of the
cavity, with two screws securing it. An ohmmeter can be used to
check the resistance of the sensor. Normal ranges (based on cavity
temperature) are shown in Table 6.
6.10 Control Module (Relay Board) and Daughter Board
The control module (and daughter board on double ovens) control the
elements, fans, door locks, lights, etc., regulate temperatures, and
monitor safety functions. The module(s) are also responsible for
communication with other modules, analyzing sensor data, regulating
line voltage, and managing user interface activities.
The control module and daughter board are accessible from the top of
the unit. Proceed to the Replacing the Control Module or Daughter
Board section if an HBL57M52UCC is not being serviced.
To Next Page
Loading...
