58300000202181 ARA EN B November 2018 Service Manual for Bosch 500 Series Built-in Wall Ovens
Page 14 of 41
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copying, disclosure, or distribution in any format is prohibited.
2. Tilt the door inward and slide the hinges into place; the hinges
should catch and the door should remain in place.
3. Open door fully to expose the hinge levers and hinge receiver
slots.
4. Flip the right and left hinge levers forward until they are fully
closed.
5. Open and close the door carefully to confirm that the door is
installed correctly and securely, and does not appear to be
askew when closed.
6. Close and open door to check operation.
6.1.2 Replacing Hinges
The doors on Bosch 500 series ovens operate using two spring
hinges. Hinges are offered in service kits which include both the RH
and LH hinges; always replace them in pairs.
To access the hinges…
1. Remove the door as described in the Removing and
Reinstalling the Door section.
2. With the porcelain-coated door liner up, remove the two
screws on each side of the door liner.
3. Remove the screws along the bottom of the door assembly.
4. Lift the liner away from the rest of the door assembly and set
aside.
5. Remove the screws at the top left and top right which secure
the handle to the door assembly.
6. Carefully lift the inner support frame with glass pack and
hinges away from the outer door glass/skin assembly and lay
flat on the work surface.
To Next Page
Loading...
