Bosch HBL8x50UC - Removing the Bosch User Interface

Service Manual for Bosch Built-in Wall Ovens
The user interface control board is assembled onto a chassis and the
entire assembly is serviced as a single unit.
Figure 12 Bosch user interfaces
4.8.1 Removing the User Interface
1. Slide unit out from wall ~ 4 inches.
2. Remove 2 T20 bolts from each side.
3. Grasp one corner of the interface panel and lift upward, then
pull it toward you (see Figure 13).
4. Repeat on the other side.
5. Disconnect the 3-wire yellow harness leading to PC control
module.
1
2
Figure 13 Each side of the user interface bracket has a tab n that rests in a slot on the
chassis u-
p
rofile o.
To remove the user interface board and chassis from the manifold
bracket, remove the 10 binding-head T20 screws securing the
interface chassis to the bracket (these screws are unique to the
interface – notice the serrated underside).
If the user interface assembly was difficult to remove, break the metal
tabs off (n) to make it easier to reinstall; use pliers to bend the tabs
back and forth until they break off.
Page 14 of 36