58300000202181 ARA EN B November 2018 Service Manual for Bosch 500 Series Built-in Wall Ovens
Page 16 of 41
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copying, disclosure, or distribution in any format is prohibited.
10. After removing and discarding all remnants of broken glass,
install the new glass pack assembly and reassemble the door.
11. Test operation of the door by fully opening and closing it
several times.
6.2 Door Latch/Motor Assembly
The motorized door latch (MDL) mechanism (120VAC 60Hz 4.3W)
has 2 switches - the door switch and the lock/unlock switch. The latch
will automatically lock when mode and temperature selectors are set
to Self Clean, and unlock when the oven cools to ~490°F. The latch
and motor are serviced as an assembly.
If the latch becomes stuck in the locked position, turning the unit off
and back on will open the latch if the cavity temperature <491°F. If
latch is stuck in a partially locked position, turn the mode and
temperature selectors to Self Clean, then turn them to Off.
If these measures fail, run a thin wire or wire coat hanger in between
the door and the front face of the oven. Figure 16 shows where to
position the wire between the latch hook (1) and the plunger (2). Slide
the wire to the left, pushing the latch hook left and releasing the latch.
There is a Door Lock Relay Test available in Service mode. See the
Service Mode section for details.
6.2.1 Replacing the Latch/Motor Assembly
1. Remove power to the oven.
2. Remove the inner screws securing the latch to the latch plate,
then remove the outer screws securing the latch plate to the
oven.
To Next Page
Loading...
