English 18
INSTALLATION
3. Extend upper support brackets and attach to sides of
cabinet with (2) screws through each bracket.
Installations using fl exible blower only:
4. Extend blower support legs and secure them to bottom of
cabinet with a screw through each leg. Tighten (4) bolts
to secure legs to fl ex blower.
2 No. 10 x 0.500
WOOD SCREW
1
FLEXIBLE
BLOWER
(4)
BOLTS
Gas cooktops only:
Install gas cooktop seal kit (HDD0RSP,
HDD6RSP) (purchase separately)
Available for application with gas cooktops - where proper
sealing is required and holes are required in cabinet base.
Kit includes trim seal, toe-kick cover plate, and cabinet hole
cover plate.
B Cut one 18¼” x 2½” (464 mm x 64 mm) OPENING
(A)* in the cabinet toe kick.
-- or --
Cut one 18¼” x 2½” (464 mm x 64 mm) OPENING
(B) in the cabinet side or back.
Mount one of the two metal grilles over this opening,
using two screws provided.
C
If you chose to cut an opening in the toe kick - you
must cut another 18¼” x 2½” (464 mm x 64 mm)
OPENING (C)* in the cabinet fl oor.
Mount the second metal grille over this opening.
* IMPORTANT NOTE:
When using toe kick opening (A) with opening (C) in cabinet
fl oor: Air must be able to fl ow freely between these two
openings - and not restricted by cabinet structure or any
other obstruction.
A
B
A
B
B
C
B
B
C
To Next Page
Loading...
