English 8
1 Parts Bag containing:
2 - Screws,
1/4-20 x .50
(12.7 mm) Hex
Head
2 - Screws,
no. 8-18 x .375
(9.5 mm) Phillips
8 - Wood Screws,
no. 10 x .50 (12.7 mm)
Phillips Round Head
2 - End Cap Trim
1 - Plastic installation
template
(see page 13) 2 - Support Legs2 - Support Legs
1 - Electrical Panel1 - Electrical Panel
2 - Upper Support 2 - Upper Support
BracketsBrackets
1 - Special key1 - Special key Installation instructionsInstallation instructions Use and Care guide
Wiring diagram
Downdraft Ventilator Housing
BEFORE YOU BEGIN
Installation review
This downdraft system can be used to exhaust cooking
by-products such as heat, steam, and smoke that may
be created while cooking using gas or electric cooktops.
With its versatile design, there are six (6) basic discharge
options - left, right, rear, front, down and recirculation. It
is important to fi rst plan your installation. The purchase of
additional accessories to complete the installation may be
necessary.
It can be mounted in an island, peninsula, or conventional
wall location. The blower (purchase separately) and
electrical panel can be mounted to the downdraft unit,
inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic
steps:
Plan the installation.
Cut out the countertop opening.
Prepare the downdraft housing.
Cut out the cabinet opening for discharge.
Mount the downdraft in the cabinet.
Install gas cooktop seal kit accessory, if applicable.
Connect the ductwork and install the blower.
Install downdraft electrical panel, if in remote
location.
Install the cooking appliance.
Install end caps to downdraft.
Check the operation.
Parts supplied
NOTE: The high level of air fl ow of this appliance may
effect the gas fl ame on some types of gas cooktops. This
is NORMAL and will cause no harm, but can be corrected
by lowering the speed of the blower.
Tools needed
Measuring tape
Pencil
Phillips screwdriver no. 2
Nut drivers - 11/32” (8.7 mm), 3/8” (9.5 mm),
7/16” (11.1 mm)
Box-end wrench
Spirit-level
Aluminum tape (DO NOT use insulating tape)
Saw
Tin snips
Work gloves
Use and care manual
...................2
Manuel d’utilisation et
d’entretien
...................................15
Manual de uso y cuidado............28
DOWNDRAF
T
HOOD HDD80050UC, HDD86050UC
HOTTE À
TIRAGE DESCENDANT HDD80050UC, HDD86050UC
VENTILADOR DE
TIRO DESCENDENTE HDD80050UC, HDD86050UC
DOWNDRAFT HDD80050UC, HDD86050UC
HOTTE ENCASTRÉE HDD80050UC, HDD86050UC
TIRO DESCENDENTE HDD80050UC, HDD86050UC
Installation instructions .................2
Instructions d’installation
............19
Instrucciones de instalación
.......
36
To Next Page
Loading...
