58300000194725 ARA EN B MAY 2016 Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 28 of 36
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
4. Lift off spark switch insulation.
4. Remove the pal nut (“push nut”) holding the switch onto the
gas valve shaft and the valve stem gasket; if not replacing,
save both for reuse.
5. Slide each spark switch off the gas valve stems.
6. Repeat with remaining switches.
7. Disconnect the harness from the spark module.
8. Install the new spark switch harness.
9. Reassemble, restore power and gas, and test operation.
WARNING
This insulation protects from electrical shock in case spilled liquids
seep below the maintop and short spark switches to the rough-in box.
If this insulation is lost, thrown out or damaged, it must be replaced.
Figure 38 View of the spark switch insulation
Figure 39 View of push nut and valve stem gasket
To Next Page
Loading...
