Wallstudsatbothcornerholes
Attaching the mounting plate to the wall
Aligning the mounting plate
CAUTION
Wear gloves to avoid cutting fingers on sharp
edges.
Note: Make sure the cabinet bottom is level.
1. Draw a vertical line on the wall at the center of the
cabinet space.
2. Use the mounting plate as a template and place it on
the wall, making sure that the tabs are touching the
bottom of the cabinet or the level line.
/c o
o o o o o o o o o o oo o o o o o o o o o o e o
o o o o o o o o o o o o o oo o o o o o o o o
E _L i-,,,11
\
,
4.
,
6.
Line up the notch and centerline of the mounting plate
to the centerline on the wall.
While holding the mounting plate, draw circles on the
wall at holes A, B, C and D.
Note: If neither A, B, C nor D is in a stud, find a stud
somewhere in the bottom area of the mounting plate
and draw a fifth circle to line up with the stud.
It is important to use at least one wood screw mounted
firmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
Drill holes on the circles:
o 3/1 6" (5 mm) holes for wood screws (stud)
o 5/8" (16 mm) holes for toggle bolts (no stud)
Attaching the mounting plate (no wall studs at corner
holes)
1. Insert the bolts into the mounting plate through the
holes designated.
o
0
0
To Next Page
Loading...
