30 | English
Main Menu Sub-menu 1 Sub-menu 2 Explanation
Indego M / M + 700: Select between the mowing settings: cut bor-
der once every full cut (default setting), once every two full cuts,
or (off) when no border cut is to be carried out.
Intensive mode The mower mows more thoroughly, returns to possible unmown
areas and mows on shorter tracks. The mower needs considerably
longer for a complete cut.
Security
Auto Lock If buttons are not pressed for 3min. they will be automatically
locked.
Recommended for safety reasons and protection against theft.
– On PIN code is required for reactivation after Auto Lock.
– Off The buttons are always ready for input.
Change PIN Changing of a PIN code requires entering of existing PIN code first.
Alarm
– On Alarm is activated.
– Off Alarm is deactivated.
Date & Time
Change the date and time.
Set Language
Change the display language.
Settings Info
System status Information on battery charge, system information and operating
and charging time for the mower.
Advanced
Wire ID Change the perimeter wire ID when possible interferences are
nearby.
Docking station
position
Use the default setting when the docking station is placed at the
edge of the lawn; and the Corner setting when placed in a corner.
Sensor setting/
Lawn condition
Select between Low (uneven ground), Normal and High (slippery
ground). Mower bump sensor will become more or less sensitive
depending on lawn condition selected.
Remap Deletes the current map of the lawn area.
Factory reset Reset the mower to factory settings will delete all personal set-
tings (not PIN).
After a factory reset, the mower will need to remap the lawn area.
Garden overview Displays the number of mapped lawn areas, their size, their wire
ID and the date of the last time the lawn area was cut.
Delete garden Delete one specific lawn area map or select to delete all maps at
once.
Tools
Level check Information about the ground angle of the mower. If the mower is
in the docking station and the dot on the display is not within the
indicated circle, the docking station must be mounted at a new,
more level location.
F 016 L94 038 | (04.11.2020) Bosch Power Tools
To Next Page
Loading...
