enSecurity
1.5 Secure Installation
WARNING - DANGER OF ELECTRIC SHOCK!
Improper installations are dangerous.
▶ Only connect and operate the device in accordance with the
information on the type plate.
▶ Connect the equipment to an AC power supply only through a
properly installed, grounded outlet.
▶ The protective conductor system of the electrical house installation must be installed
in accordance with the regulations.
▶ Never supply the device via an external switching device,
e.g. B. timer or remote control.
▶ When the device is installed, the mains plug of the mains
connection cable must be freely accessible, or if free access is not
possible, an all-pole separator must be installed in the
permanently installed electrical installation in accordance with the
installation regulations.
▶ When setting up the device, make sure that the power cord
is not pinched or damaged.
Damaged insulation of the power cord is dangerous.
▶ Never bring the power cord into contact with heat sources.
WARNING - Danger of explosion!
If the ventilation openings of the device are closed, a flammable
mixture of gas and air can form in the event of a leak in the
refrigeration circuit.
▶ Do not close ventilation openings in the device housing or in the
installation housing.
WARNING - Fire Hazard!
Using an extended power cord and unapproved adapters is
dangerous.
▶ Do not use extension cords or multiple socket strips.
▶ Only use adapters and power cords approved by the
manufacturer.
8th
To Next Page
Loading...
