en
29
Appliance self-test
Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.
Starting the appliance self-test
1. Switch off the appliance and wait 5
minutes.
2. Switch on the appliance and within the
first 10 seconds, press and hold the
°C button and the "–" setting button
for 3–5 seconds until an audible
signal sounds.
The self-test programme starts.
When the self-test ends and an audible
signal sounds twice, your appliance is
in working order.
If 5 audible signals sound, there is an
error. Inform customer service.
Ending the appliance self-test
When the programme has ended, the
appliance switches over to normal
operation.
Customer service,
product / production
number and technical
data
Customer service
If you have any queries, are unable to
rectify faults on the appliance yourself or
if your appliance needs to be repaired,
contact Customer Service.
You can solve many problems yourself
by consulting the information on
troubleshooting in these instructions or
on our website. If this is not the case,
contact our Customer Service.
We will always find an appropriate
solution and try to avoid unnecessary
visits being made by a Customer Service
technician.
With any warranty claims, we will make
sure that your appliance is repaired by
trained Customer Service technicians
using genuine spare parts, including
after the manufacturer's warranty has
expired.
Fault Possible cause Remedial action
Condensation accumulates
on the surface of the
appliance and on the shelves
inside.
The effect is reinforced if
ambient temperatures are
warm and humid.
Wipe away the water with a soft, dry cloth.
■ Open the appliance as briefly as possible
■ Make sure that the appliance is always
closed properly.
To Next Page
