11English
8 789 929 560
LW20/30E
BA
RR940503CR
10. Rating plate
11. Mains fuse holder
with replacement fuse
(slow-blow 4 A)
12. Mains connection for inlet con-
nector for non-heating appara-
tus (230/240 V, 50 Hz)
13. Charging leads
Positive (+) = Red
Negative (–) = Black
14. Holder for charging leads and
storage holder for operating
instructions
Installation
The charger must be set up
horizontally on a firm surface.
The location (e.g. shelf) must be
sufficiently stable.
Pay attention to unit weight.
Do not cover the charger.
Set up the charger so that there
is a clearance of at least 15 cm
on all sides for ventilation purpo-
ses.
Protect the charger against
moisture.
The charger must only be
connected to a mains power
supply where the mains vol-
tage agrees with the voltage
rating on the rating plate (10).
Charging batteries
Set the voltage selector
switch (9) to ”0” (OFF) before
connecting the charger to the
mains supply!
Before charging the instruc-
tions of the battery manufac-
turer must be read and then
followed.
Wear protective goggles.
Immediately wash off acid
splashes on the skin or clo-
thing with large quantities of
water. If necessary consult a
doctor.
Charge only fault-free batte-
ries with a rated voltage of
12 V or 24 V.
Only tested batteries must be
connected in parallel for char-
ging.
Maintenance-free batteries
must not be charged together
with standard batteries.
To Next Page
Loading...
