Bosch MMB6172SN - Cleaning and Servicing; Cleaning Products; Closing the To-Go Blender Jug; Dishwasher-Safe Compon- Ents

en Cleaning and servicing
32
4. Screw the To-Go blade insert and
the To-Go blender jug in tightly.
→Fig.
16
– The and markings must
match up.
– You can only connect the To-Go
blade insert to the main unit
when the To-Go blender jug is
screwed on fully.
5. Turn the To-Go blender jug upside
down.
→Fig.
17
6. Place the To-Go blade insert on
the main unit and rotate it in a
clockwise direction until it locks
into place.
→Fig.
17
7. Set the rotary switch to the recom-
mended speed.
→Fig.
18
Tip:We recommend pausing oper-
ation several times when preparing
smaller quantities of baby food in
the To-Go blender jug.
Processing can also take place
with instantaneous switching.
→"Using instantaneous switching",
Page31
8. Process the ingredients until you
achieve the required result.
9. To end the operation, set the rotary
switch to
⁠.
→Fig.
19
7.9 Closing the To-Go
blender jug
Requirement:The appliance has
stopped.
1. Turn the To-Go blender jug anti-
clockwise and remove it from the
main unit.
→Fig.
20
2. Turn the To-Go blender jug and un-
screw the To-Go blade insert.
→Fig.
20
3. Insert the seal for the lid.
→Fig.
21
4. Close the mouthpiece on the lid.
→Fig.
21
5. Screw the lid and the To-Go
blender jug in tightly.
→Fig.
21
8 Cleaning and servicing
To keep your appliance working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
8.1 Dishwasher-safe compon-
ents
Find out here which components can
be put in the dishwasher.
ATTENTION!
Some parts may be damaged if they
are put in a dishwasher.
▶ Only put dishwasher-safe parts in
the dishwasher.
▶ Only use programmes that do not
heat the water above 60°C.
▶ Do not wedge plastic parts in the
dishwasher.
This overview describes the cleaning
process for the components.
→Fig.
22
8.2 Cleaning products
Find out here which cleaning
products are suitable for your appli-
ance.