Bosch MMB6172SN - Page 36

en Troubleshooting
36
Fault Cause and troubleshooting
The To-Go blade in-
sert cannot be con-
nected to the main
unit.
Outlet protection is active.
▶ Screw the To-Go blade insert and the To-Go
blender jug in by turning them in a clockwise direc-
tion.
a The To-Go blender jug and To-Go blade insert are
fully and tightly screwed in.
a The and markings match up.
To-Go blender jug is
leaking.
Seal is missing from the lid.
▶ Insert the seal.
Liquid is leaking from
the blade insert.
Seal between the blender jug and the blade insert is
missing.
▶ Insert the seal on the EasyClick blade insert.
a The seal is seated in the groove.
a The sealing lips point in the direction of the blender
jug.
a The smooth sealing surface lies against the EasyC-
lick blade insert.