DINION inteox 7100i IR | FLEXIDOME inteox 7100i Configuration | en 21
Bosch Security Systems B.V.
User manual
2021-08 | V01 | DOC
Global configuration
Notice!
These options can also be configured individually for all stamping settings.
Any changes to the global configuration settings will be applied to all stamping settings!
– Stamping size
Select the desired font size of the overlays on the OSD: Normal Large or Custom.
Select Custom to enable the Font size (%) field.
– Text color
Select the color for the alarm message to be displayed in.
– Background color
Select the background color for the alarm message to be displayed in.
If you have enabled the Transparent background option, the background color is not
displayed in the OSD.
Camera name stamping
– Position
Select the position of the camera name overlay in the drop-down box. It can be displayed at
the Top, at the Bottom, or at a position of choice using the Custom option, or it can be set to
Off for no overlay information.
If the Custom option is selected, enter values in the X and Y position fields.
Optionally, tick the Underlay with full-width bar box to place a full-width background-bar
beneath the time stamp.
Notice!
Camera / video names can be changed under General > Identification.
Logo stamping
– Logo
To place a logo on the image, select and upload an uncompressed .bmp file with a maximum
size of 300x300 pixels and 256 colors to the camera.
– Logo position
Use the drop-down menu to select the position of the logo or to hide it (Off).
Time stamping
– Display milliseconds
Click this check box to display the milliseconds in the time stamp.
Note: This information can be useful for recorded video images, however, it does increase the
processor's computing time.
Alarm mode stamping
– Alarm message
Enter the message to be displayed on the image in the event of an alarm. The maximum text
length is 32characters.
To Next Page
Loading...
