To Next PageTo Next Page
Need help?Do you have a question about the Bosch NDE-3503-AL and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| Alarm input/output | Yes |
| Placement supported | Indoor & outdoor |
| Connectivity technology | Wired |
| Form factor | Dome |
| Mounting type | Ceiling |
| Product color | White |
| Protection features | Impact resistant |
| International Protection (IP) code | IP66 |
| Pan range | 0 - 355 ° |
| Tilt angle range | 0 - 85 ° |
| Angle of rotation | 355 ° |
| Adjustment shutter speed | Auto |
| Bluetooth | No |
| Ethernet interface type | 100 Gigabit Ethernet |
| Supported network protocols | IPv4, IPv6, UDP, TCP, HTTP, HTTPS, RTP/RTCP, IGMP V2/V3, ICMP, ICMPv6, RTSP, FTP, ARP, DHCP, APIPA (Auto-IP, link localaddress), NTP (SNTP), SNMP (V1, V3, MIB-II), 802.1x, DNS, DNSv6, DDNS (DynDNS.org, selfHOST.de, no-ip.com), SMTP, iSCSI, UPnP (SSDP), DiffServ (QoS), LLDP, SOAP, Dropbox™, CHAP, digest authentication |
| Sensor type | CMOS |
| DC output voltage | 12 |
| Power source type | DC, PoE |
| Power consumption (max) | 9.5 W |
| Power consumption (typical) | 3.1 W |
| Power consumption (Power over Ethernet (PoE)) | 10.5 W |
| Compatible memory cards | SDHC, SDXC |
| Total megapixels | 5 MP |
| Maximum resolution | - pixels |
| Video compression formats | H.264, M-JPEG, H.265, HEVC |
| Supported graphics resolutions | 1920 x 1080 (HD 1080), 1280 x 720 (HD 720), 768 x 432, 640 x 480 (VGA) |
| LED type | IR |
| Infra-red wavelength | 850 nm |
| Night vision distance | 30 m |
| Number of illumination LEDs | 3 |
| Number of cameras | - |
| Sample rate | 8 kHz |
| Signal-to-Noise Ratio (SNR) | 50 dB |
| Ethernet LAN (RJ-45) ports | 1 |
| Storage temperature (T-T) | -30 - 70 °C |
| Operating temperature (T-T) | -30 - 50 °C |
| Storage relative humidity (H-H) | 0 - 98 % |
Specifies required hardware and software for accessing the camera via a web browser.
Details the steps to connect the camera to the network and access it via a web browser.
Guides on viewing live video, selecting streams, ROI, and Digital I/O controls.
Setting up user accounts and authorization levels for access control.
Settings for image quality, rotation, encoding, lens adjustment, and installer menu.
Configuration for storage media, recording profiles, and scheduling.
Setup for alarm triggers, Video Content Analysis (VCA), audio alarms, and email notifications.
Setting up video analytics for motion detection, tampering, and metadata generation.
Settings for IP address, DNS, protocols, network services, and management.
Instructions for performing a hardware reset to restore factory default settings.
