Need help?Do you have a question about the Bosch NDP-4502-Z12 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | NDP-4502-Z12 |
| Category | Security Camera |
| Language | English |
Steps to connect to the unit via IP address using a web browser.
Setting a strong password for device access to ensure security.
How to configure unit settings and save changes effectively.
Setting authentication modes, passwords, and certificates.
Managing user authorization levels and creating new users.
Frame rate, rotation, mirror, coding, LED, reboot, defaults.
Defining camera location and perspective for Video Analytics.
Height, sketch calibration, VCA profiles, and global calibration.
Focal length, sketch window calibration, and horizon settings.
Using Cartesian and WGS 84 systems for positioning.
Setting up video encoding profiles and presets.
Overview of pre-defined profiles for image quality and bit rate.
Expert settings for I-frame, P-frame quality, GOP structure.
Selecting resolutions and options for video streams.
Available resolutions for Stream 1 and Stream 2.
Defining and managing privacy masks to block areas.
Setting mask patterns, enabling/disabling, enlargement, and zoom threshold.
Autofocus, focus range, speed, IR correction, zoom speed.
Auto pan, inactivity, freeze frame, turbo mode, and limits.
Azimuth, proportional speed, pan/tilt limits for PTZ.
Defining, editing, and managing pre-positions and tours.
Creating and managing pre-positions and tours.
Overview of recording to iSCSI or SD card, tracks, and VRM.
Configuring iSCSI and local SD card storage.
Activating, configuring, formatting, and deactivating storage.
Creating and managing recording profiles for different scenarios.
Stream profiles, pre-positions, and recording inclusions.
Setting up continuous, pre-alarm, or no automatic recording.
Configuring IP addresses for alarm event connections.
Configuring VCA profiles, renaming, and turning off VCA.
Creating rules to link inputs to outputs for automatic responses.
Setting up input/output options and AUX commands for alarm rules.
Configuring physical alarm triggers and naming inputs.
Setting relay idle state, operating mode, and output name.
Configuring IP address assignment via DHCP or Link-Local.
Updating firmware, upload history, and configuration files.
To Next Page
