Bosch NIT5065UC - Time Programming Function; Switching an Element off Automatically

Time programming function
Switching an element
off automatically
It is programmed as follows
This function may be used in two different ways:
- to switch an element off automatically
- as a timer
WARNING: The timer should not be used as a safety measure in order to leave the
cooktop unsupervised during use, especially at high temperatures. Breaded items
can smoke. Overheated food and oil can catch on fire. Supervise the cooktop even
ifthe time program is on.
Enter the time period for the required element. The element will switch off
automatically once this time has elapsed.
The cooktop must be switched on.
1. Select the element and heat setting required. Then press the Timer symbol
twice. The uu,nnmin, and __ indicators light up.
2. Program the time using symbols 1 to 9.
Timer
\.
\
,
0 1 o 2
Once the cooking time has
elapsed
Changing the time
Cancelling the automatic
OFF function
Recommendations and
warnings
After a few seconds, the timer will start to count down.
The cooking time for the selected element will be shown on the display.
The element switches off. A warning beep sounds. 0.0 appears on the element
display and O0 appears on the timer display. The indicators switch off and the
display beep turns off by pressing the Timer symbol.
Select the element and then press the Timer symbol twice. The min, __
indicators light up.
and -&
Change the cooking time using the symbols 1 to 9.
Select the element and then press the Timer symbol twice. The rain, __
indicators light up. Then press the 0 symbol until uunnis displayed.
and -&
To program a cooking time of less than 10 minutes, always press 0 before selecting
the required value. Any cooking time can be programmed up to 99 minutes. After a
power outage, this function is cancelled.
19