To Next PageTo Next Page
Need help?Do you have a question about the Bosch PHG 630 DCE and is the answer not in the manual?
General| Input power | 2000 W |
|---|---|
| Power source | AC |
| Maximum airflow | 500 l/min |
| Minimum airflow | 150 l/min |
| Working temperature (max) | 630 °C |
| Working temperature (min) | 50 °C |
| Number of airflow settings | 3 |
| Soft grip | Yes |
| Product color | Black, Green |
Weight and Dimensions| Weight | 900 g |
|---|
The power tool is intended for forming, welding plastic, and removing paint.
Observe correct mains voltage and ensure it agrees with the machine's nameplate.
Instructions for turning on the power tool for different models.
Instructions for turning off the power tool and cooling down procedures.
Select between different air flows and temperature combinations using the switch.
Regulate temperature in hot air settings II and III; fixed at 50°C in cold air setting I.
Place the power tool on the standing surface to cool down or free hands.
Remove heat protection collar for hard-to-reach locations; be careful of hot nozzle.
Soften varnish or adhesives with hot air and remove using a scraper.
Use reduction nozzle and welding shoe; heat seam until doughy for welding.
Use angle nozzle to heat frozen water pipes from the outside to the middle.
Use reduction or reflector nozzle for soldering; warm location and apply solder.
Keep machine and ventilation slots clean; pull mains plug before any work.
Follow European Guideline 2002/96/EC for waste electrical and electronic equipment.
