Troubleshooting en
53
Fault Cause and troubleshooting
Remnants of food on
tableware.
Filters are inserted incorrectly and/or not engaged.
1. Insert the filters properly.
→"Filter system", Page47
2. Engage the filters.
Washing programme selected too weak.
▶ Select a more intensive washing programme.
→"Programmes", Page20
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food and do not
prerinse tableware.
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tall narrow receptacles in corner areas are not rinsed
adequately.
▶ Do not position tall narrow receptacles at too great
an angle or in corner areas.
Top baskets on right and left are not set to same
height.
▶ Set the upper basket on the left and right to the
same height.
→"Top basket", Page24
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Amount of rinse aid to be dispensed is set too high.
▶ Set the rinse aid system to a lower setting.
→"Setting the amount of rinse aid", Page31
No rinse aid has been added.
▶ Add rinse aid.
→"Adding rinse aid", Page30
Detergent residue is present in the final rinse. Lid of
the detergent dispenser is blocked by tableware items
and will not open fully.
To Next Page
Loading...
Need help?
General
