en
6
Installing the spacers
Remove two screws with screwdriver first, and take out
the spacers from plastic bag and fix it to the back of
theappliancethroughthescrewsthen.Thisensures
that there is a minimum distance between the appli
ance and the wall.
Installation dimensions and door opening
angle
W
W1
W2
D
D1
135°130°
W W1 W2 D D1
908 mm
418 mm 277 mm 628 mm 1171 mm
Fixing the door handle
Before you use the product, please check the handles
of the appliance. If a handle is loose, you should fix it
with the hexangular screwdriver in the clockwise
direction, then it can be used normally.
Aligning the appliance
To ensure that the appliance functions correctly, it must
be set level with a spirit level.
Ø For sufficient leveling and air circulating in the lower
rear section of the appliance, the bottom feet may
need to be adjusted.
Ø To allow the doors to selfclose, tilt back the top
backwards at about 15 mm or 0.5° by turning the
adjustable feet.
Ø Whenever you want t o move the appliance,
remember to turn the feet back up, so that the
appliance can roll freely.
Ø The rollers, which are not castors, should be only
used for forward or backward movement. Moving
the refrigerator sideways may damage your floor
and the rollers.
Ø Reinstall the appliance when relocating.
0.5°
15 mm
adjustable bottom feet
To Next Page
Loading...
Need help?
General
