9
Automatic time limit
If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
” and ‰ flash alternately in the
hotplate indicator.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Basic settings
Your appliance has various basic settings. You can adapt these
settings to your needs.
Changing the basic settings
The hob must be switched off.
1.Switch on the hob.
2.Within the next 10 seconds, touch the @ symbol for 4
seconds
™ and ‚ flash alternately in the left-hand display; ‹ lights up in
the right-hand display.
3.Touch the @ symbol repeatedly until the desired indicator
appears in the left-hand display.
4.Touch the + symbol repeatedly until the desired setting
appears in the right-hand display.
5.Touch the @ symbol for 4 seconds.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
Indicator Function
™‚
Automatic childproof lock
‹ Switched off.*
‚ Switched on.
™ƒ
Audible signal
‹ Confirmation signal and operation error signal switched off.
‚ Only operation error signal switched on.
ƒ Confirmation signal and operation error signal switched on.*
™ˆ
Activation of the filament circuits
‹ Switched off.
‚ Switched on.
ƒ Last setting before the hotplate was switched off.*
™‹
Reset to basic setting
‹ Switched off.
‚ Switched on.
*Basic setting
To Next Page
Loading...
