36 | English
1 609 92A 1F3 | (20.8.15) Bosch Power Tools
a) Indirect height measurement
Press the k button and select the button for indirect height measurement .
Pay attention that the measuring tool is positioned at the same height as the bottom
measuring point.
b) Double indirect height measurement
Press the k button and select the button for double indirect height measurement .
Pay attention that the reference plane of the measurement (e.g. the rear edge of the
measuring tool) remains exactly at the same location for all individual measurements
within a measuring sequence.
c) Indirect length measurement
Press the k button and select the button for indirect length measurement .
Pay attention that the measuring tool is positioned at the same height as the sought
measuring point.
Inclination Measurement
Press the k button and select the button for grade measurement .
Inclination measurement is used to measure a slope or incline
(e.g. of stairs, railings, when fitting furniture, laying pipes, etc.).
The left-hand side of the measuring tool serves as the reference
level for grade measurement. If no incline angle is shown on the
display, the measuring tool was tipped sideways too severely dur-
ing measurement.
You can hold the current measured value by pressing the measur-
ing button 1 or the button on the display.
Digital Spirit Level
Press the k button and select the button for the digital spirit level .
The digital spirit level is used to check the horizontal alignment of
an object simultaneously on two axes (e.g. washing machine, re-
frigerator, etc.).
The rear of the measuring tool serves as the reference level for the
digital spirit level.
You can hold the current measured value by pressing the measur-
ing button 1 or the button on the display.
OBJ_BUCH-2326-003.book Page 36 Thursday, August 20, 2015 8:43 AM
To Next Page
Loading...
