English | 21
Bosch Power Tools 1 609 929 W68 | (3.3.10)
Practical Advice
The following tips are for performing length or mitre cuts (90°/45°).
For working instructions and practical advice on
the PLS 300 saw station, log onto:
www.bosch-do-it.com/pls300
For further questions, please refer to our cus-
tomer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
Problem Cause Corrective Measure
Cut runs out of centre
Guide rail 4 not affixed Affix guide rail according to height
of workpiece; provide for firm
clamping of the workpiece
Saw blade too thin Use the provided saw blade
T144DP
Sawing feed too high (apply less
feed with power tool)
Saw through workpiece applying
less and uniform feed
Do not apply pressure against the
side stops 5
Angle adjustment of base plate to
saw chain incorrect
Align base plate to saw chain and
retighten
Saw blade does not run in guide
roller (see figure E)
Adjust guide roller in such a man-
ner that the saw blade is guided
(see operating instructions of the
jigsaw)
Wood surface unsatisfac-
tory after cut
Workpiece was sawn with the
visible side facing up
Saw workpiece with the visible
side facing down (see figure A3)
Saw blade worn Insert new saw blade
Sawing feed too high (apply less
feed with power tool)
Saw through workpiece applying
less and uniform feed
Do not apply pressure against the
side stops 5
Sawing was carried out with orbit-
al action switched on
Switch orbital action off
OBJ_BUCH-1219-001.book Page 21 Wednesday, March 3, 2010 9:25 AM
To Next Page
Loading...
