Bosch PLS 300 - Tile Cutting Practical Advice; Maintenance and Service

English | 23
Bosch Power Tools 1 609 929 W68 | (3.3.10)
Practical Advice
For working instructions and practical advice on
the PLS 300 saw station, log onto:
www.bosch-do-it.com/pls300
For further questions, please refer to our cus-
tomer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
Maintenance and Service
Maintenance and Cleaning
If the saw station should fail or become dam-
aged despite the care taken in manufacture and
testing, repair should be carried out by an au-
thorised customer services agent for Bosch
power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the saw sta-
tion.
Cleaning
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Warranty Condition
Through faulty usage, sawing into the guide rail
4 or bridge 8 can occur. No warranty claims
whatsoever shall arise thereof, as this does not
affect the function of the saw station.
Problem Cause Corrective Measure
Tile does not break along
the cutting line
Scoring line not continuous from
front to end
Apply more pressure (uniformly)
when scoring the tiles and score
over the complete surface
Tile cutter 14 incorrectly inserted Insert tile cutter correctly
(see figure H1)
Surface structure of tile uneven Apply more pressure (uniformly)
when scoring and increase the
scoring (cutting) speed
Break-off cones incorrectly posi-
tioned when breaking the tile
Position break-off cones below
the cutting line and at the edges of
the tile (see figure H3)
For diagonal cuts, position the
break-off cones somewhat further
toward the inside
Scoring line not continuous from
front to end
Increase scoring pressure when
cutting the tiles
OBJ_BUCH-1219-001.book Page 23 Wednesday, March 3, 2010 9:25 AM