To Next PageTo Next Page
Need help?Do you have a question about the Bosch Professional GBH GBH 26 V and is the answer not in the manual?
General| Drilling Capacity in Steel | 13 mm |
|---|---|
| Drilling Capacity in Wood | 30 mm |
| Vibration Control | Yes |
| Tool Holder | SDS plus |
| Drilling Capacity in Concrete | 26 mm |
| Optimum Range of Application in Concrete | 8-16 mm |
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools.
The machine is intended for hammer drilling in concrete, brick and stone, as well as for light chiselling work.
The numbering of the product features refers to the illustration of the machine on the graphics page.
Sound emission values determined according to EN 60745-2-6. Typically the A-weighted noise levels of the product are:
Use only the battery chargers listed on the accessories page. Only these battery chargers are matched to the lithium-ion battery of your power tool.
The battery 11 is equipped with two locking levels that should prevent the battery from falling out when pushing the battery unlocking button 18 unintentionally.
The auxiliary handle 16 can be set to any position for a secure and low-fatigue working posture.
To work with tools without SDS-plus (e.g., drills with cylindrical shank), a suitable drill chuck must be mounted.
The SDS-plus quick change chuck 2 can easily be replaced against the quick change keyless chuck 1 provided.
The SDS-plus drill chuck allows for simple and convenient changing of drilling tools without the use of additional tools.
Push back the locking sleeve 5 and remove the tool.
Note: Do not use tools without SDS-plus for hammer drilling or chiselling!
Turn the sleeve of the key type drill chuck 24 with the drill chuck key in anticlockwise direction until the drilling tool can be removed.
Note: Do not use tools without SDS-plus for hammer drilling or chiselling!
Držite čvrsto prsten držač 30 promenljive brze stezne glave. Otvorite prihvat za alat okrećući prednju čauru 29 u pravcu strelice, da bi se alat mogao izvaditi.
A GDE 18V-16 (accessory) is required for extracting concrete dust and stone dust.
Set the rotational direction switch 8 to the centre position to protect the power tool against accidental starting.
The operating mode of the power tool is selected with the mode selector switch 13.
The required drilling depth X can be set with the depth stop 17.
The chisel can be locked in 44 positions. In this manner, the optimum working position can be set for each application.
To work with screwdriver bits, a universal bit holder 31 with SDS-plus shank (accessory) is required.
