To Next PageTo Next Page
Need help?Do you have a question about the Bosch Professional GSB 18V-90 C and is the answer not in the manual?
General| Voltage | 18 V |
|---|---|
| Max Torque | 90 Nm |
| Chuck Type | Keyless chuck |
| Weight excl. battery | 1.2 kg |
| Chuck capacity | 1.5 - 13 mm |
| Battery type | Li-Ion |
| Max. drilling diameter in wood | 38 mm |
| Max. drilling diameter in steel | 13 mm |
| Max. screw diameter | 10 mm |
| Torque (soft/hard) | 28 Nm / 90 Nm |
| Chuck capacity, min./max. | 1.5 - 13 mm |
Keep work area clean and well lit. Avoid explosive atmospheres. Keep children away.
Ensure correct plugs, avoid earthed surfaces, keep away from rain/wet, don't abuse cord.
Stay alert, use PPE, prevent unintentional starting, don't overreach, dress properly.
Operate at correct speed, start low, apply pressure in line with bit.
Secure workpiece, use detectors, wait for stop, handle battery with care.
Driving/loosening screws, drilling, impact drilling, Bluetooth connectivity.
Lists numbered components of the power tool.
Noise emission values determined according to EN 62841-2-1.
Vibration total values and uncertainty determined according to EN 62841-2-1.
Use specified chargers, charge before first use, charge anytime.
Shows battery charge state via LEDs.
Remove battery, open chuck, insert tool, tighten chuck.
Health hazards of dust, ventilation, respirator, avoid accumulation.
Insert battery, set rotational direction, set operating mode, switch on/off.
Adjust speed by pressure, pre-select torque for screwdriving.
Overload protection, precision clutch, KickBack Control, and battery status.
Shows tool status (OK, critical, overheating, rapid shut-off, connectivity).
Functions available with Bluetooth® Low Energy Module GCY 42.
For hanging the power tool on a belt for convenience.
Redistribution and use terms for ARM software.
Redistribution and use terms for Infineon software.
Redistribution and use terms for Petteri Aimonen software.
