English | 15
(1)
Keyless chuck
(2)
Torque presetting ring
(3)
Operating mode presetting ring
(PSB 18 LI-2 Ergonomic)
(4)
Gear selector switch
(5)
On/off switch
(6)
Rotational direction switch
(7)
Battery release button
(8)
Battery charge indicator
(9)
Battery
A)
(10)
"PowerLight"
(11)
Handle (insulated gripping surface)
A)
Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
Cordless drill/driver PSR 18 LI-2 Ergonomic PSB 18 LI-2 Ergonomic
Article number
3 603 JB0 1.. 3 603 JB0 3..
Rated voltage V= 18 18
No-load speed
– 1st gear min
-1
0–430 0–430
– 2nd gear min
-1
0–1400 0–1400
Impact rate min
-1
– 0–22500
Max. torque, hard/soft screwdriving application ac-
cording to ISO 5393
Nm 32/28
A)
32/28
A)
Max. drilling diameter
– Steel mm 13 13
– Wood mm 38 38
– Masonry mm − 11
Max. screw diameter mm 10 10
Chuck capacity mm 1.5–13 1.5–13
Drill spindle thread 1/2" 1/2"
Weight according to EPTA-Procedure 01:2014 kg 1.2 1.3
Permitted ambient temperature
– during charging °C 0... +35 0... +35
– during operation
B)
and during storage °C -20 to +50 -20 to +50
Recommended batteries PBA 18V...W-. PBA 18V...W-.
Recommended chargers
C)
AL 18... AL 18...
A) Depends on battery in use
B) Limited performance at temperatures <0°C
C) The following chargers are not compatible with the PBA rechargeable battery: AL 1814 CV, AL 1820 CV, AL 1860 CV
Noise/Vibration Information
Noise emission values determined according to
EN62841-2-1.
Typically, the A-weighted sound pressure level of the power
tool is 74dB(A). Uncertainty K=5dB. The noise level when
working can exceed the volume stated. Wear hearing pro-
tection
Total vibration values a
h
(triax vector sum) and uncertainty K
determined according to EN62841-2-1:
Drilling into metal: a
h
=2.5 m/s
2
, K=1.5 m/s
2
,
Impact drilling into concrete: a
h
=17 m/s
2
, K=2.0 m/s
2
.
Screwdriving: a
h
=2.5 m/s
2
, K=1.5 m/s
2
.
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
Bosch Power Tools 1 609 92A 4YA | (28.05.2019)
To Next Page
Loading...
Need help?
General
