18 | English 2 609 932 567 • 14.8.06
Technical Data
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 85 dB(A); sound power level
96 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
The vibration emission level given in
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Declaration of Conformity
PST 700 PE: We declare under our sole responsibility
that this product is in conformity with the following
standards or standardization documents: EN 60745
according to the provisions of the directives
89/336/EEC, 98/37/EC.
PST 800 PEL/PST 900 PEL: We declare under our
sole responsibility that this product is in conformity with
the following standards or standardization documents:
EN 60745, EN 60825-1 according to the provisions of
the directives 89/336/EEC, 98/37/EC.
14.08.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Jigsaw PST 700 PE PST 800 PEL PST 900 PEL
Article number 3 603 C51 1.. 3 603 C52 1.. 3 603 C53 1..
Laser module – zz
Stroke rate control z – –
Stroke rate preselection – zz
Orbital action z z z
Rated power input W 600 620 650
Output power W 330 340 360
Stroke rate at no load n
0
spm 500–3100 500–3100 500–3100
Stroke mm 23 23 23
Cutting capacity, max.
–in wood
– in aluminium
– in non-alloy steel
mm
mm
mm
70
12
5
80
15
6
90
20
10
Bevel cuts (left/right), max. ° 45 45 45
Weight according to EPTA-Procedure 01/2003 kg 2.1 2.1 2.2
Protection class / II / II / II
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Laser module (PST 800 PEL/PST 900 PEL)
Laser type nm
mW
650
<1
Laser class 2M
Operating and storage
temperature
°C 0 ... +40
Batteries 3 x 1.5 V
(LR44)
WARNING
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-250-001.book Page 18 Monday, August 14, 2006 10:17 AM
To Next Page
Loading...
Need help?
General
