Appliance settings en
39
Removing laundry/switching
off the appliance
1. Press the # button till the indicator
lamp turns off, release the button.
The appliance is switched off.
2. Open the door and remove the
laundry.
3. Turn off the water tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate.
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q Appliance settings
Appliance settings
Automatic switch-off
If the appliance is not operated for a
prolonged period (at least 20 minutes,
depending on the water level inside of
appliance), it will automatically switch
off before the programme starts or after
the programme has ended. Press the
power button # again to switch on the
appliance.
Basic settings
To access the basic settings, touch and
hold the Á (Silent) button for approx. 3
seconds. The control panel show:
You can change the following basic
settings:
■ The volume of the end signal.
■ The volume of the buttons.
■ The brightness of the Touch-Display.
■ Switching the Drum Clean
information signal on/off.
End signal
You can select position 1 and use the
˜ button to adjust the volume of the
end signal, e.g. ‘- „.
Possible setting values:
0 off
1 quiet
2 medium
3 loud
4 very loud
To Next Page
Loading...
Need help?
General
