en Fault, what to do?
36
Fault table
Fault Reason Remedial action
“Check water supply”
display lights up.
Supply hose kinked. Install supply hose without kinks.
Water supply turned off. Turn on water supply.
Water supply jammed or
calcified.
Turn on water supply.
Flow rate must be at least 10 l/min. when
water supply is open.
Filter in the water supply blocked. Switch off the appliance and pull out the
mains plug. Turn off water supply.
Unscrew water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Fault code “:‹ˆ is lit. Intake opening (on right inside of
appliance) covered by utensils.
Arrange utensils so that the intake
opening is not obstructed.
Fault code “:‚ƒ is lit. Heating element calcified or
soiled.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.~ " Water softening
system/special salt" on page 14
Fault code “:‚… is lit. Water protection system
activated.
Turn off water supply.
Call customer service and quote the fault
code.
Fault code “:‚† is lit.
Fault code “:‚‡ is lit. Constant water supply.
Fault code “:ƒƒ is lit. Filters 1Z are soiled or
blocked.
Clean filters. ~ "Filters" on page 34
*Depending on the features of your dishwasher
To Next Page
Loading...
Need help?
General
