en Fault, what to do?
38
Utensils not dry. Not enough rinse aid in the
dispenser, or none at all.
Refill rinse aid.
Programme without drying was
selected.
Select programme with drying.
~ "Overview of programmes"
on page 26
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used
has a poor drying performance.
Use different combination detergent with
better drying performance. Use of rinse
aid also improves the drying performance.
ExtraDry to increase drying not
activated.
Activate ExtraDry. ~ "Operating the
appliance" on page 29
Utensils were removed too early
or drying process had not ended
yet.
Wait until the programme ends, or wait
until 30 minutes after the end of the
programme before removing the utensils.
The eco rinse aid used has a
limited drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry. Cutlery not arranged properly in
the cutlery basket.
Separate cutlery if possible, prevent
contact points.
Cutlery not arranged properly in
the cutlery drawer.
Arrange cutlery properly and separate if
possible.
Appliance interior wet after
wash cycle.
No appliance fault. On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Fault Reason Remedial action
*Depending on the features of your dishwasher
To Next Page
Loading...
Need help?
General
