EasyManua.ls Logo

Bosch PVQ731F15E/20 - Cookware Test; Power Limitation

Bosch PVQ731F15E/20
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Basic settings
14
Basic settings
17  Basic settings
You can configure the basic settings for your appliance to meet your needs.
17.1 Overview of the basic settings
Display Setting Value
⁠ Childproof lock - Manual.
1
Automatic.
– Switched off.
⁠ Signal tones – Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
.
⁠ Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
– Switched off.
1
– Switched on.
⁠ Automatic switch-off of the cooking zones. – switched off.
1
⁠- - minutes until the appliance switches off auto-
matically.
⁠ Duration of the timer end signal tone – 10seconds
1
– 30seconds
- 1 minute
⁠ Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
- Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
⁠ Time for selecting the cooking zone - Unlimited: You can adjust the last selected cooking
zone without having to select it again.
1
– Limited: You can adjust the last selected cooking
zone within 10seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
⁠ Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
⁠ Set circulating-air mode or air extraction
mode.
- Configure circulating-air mode.
1
- Configure air extraction mode.
⁠ Setting automatic start - Switched off.
- Switched on: The ventilation system starts at a power
level in accordance with the relevant power levels for the
cooking zones.
1
1
Factory setting

Related product manuals