Operating the appliance en
13
Selecting a hotplate and heat setting
The hob must be switched on.
1. Touch the ø symbol for the required hotplate.
The ‹ symbol lights up and the ¬ symbol
underneath.
2. Then select the required heat setting from the
settings range.
The heat setting is set.
Changing the heat setting
Select the hotplate and then set the required heat
setting in the control panel.
Switch off the hotplate
Select the hotplate and set it to ‹ in the programming
panel. The hotplate turns off and the residual heat
indicator appears.
Notes
■ If no pan has been placed on the hotplate, the
selected power level flashes. After a certain time has
elapsed, the hotplate switches off.
■ If a pan has been placed on the hotplate before
switching on the hob, it will be detected within
20 seconds of pressing the main switch and the
hotplate will be selected automatically. Once
detected, select the power level within the next
20 seconds or the hotplate will switch off.
If more than one pan is placed on the hob, only one
will be detected when switching it on.
■ The ventilation system must be switched off
separately. ~ "Switching off the ventilation system"
on page 13
Switching the ventilation system on and off
Notes
■ Always adjust the setting according to the current
conditions. To eliminate strong cooking smells,
select a high fan setting.
■ If no metal grease filter is available, the ventilation
system cannot be switched on. Insert the metal
grease filter. The hob functions are also available if
there is no metal grease filter.~ "Cleaning"
on page 24
■ Do not obstruct the ventilation openings. Do not
place objects on the filter cover, as this will reduce
the power of the ventilation system.
■ Using tall items of cookware may prevent the
extraction system from working at optimum power.
The extraction power can be improved by placing a
lid on the cookware at an angle.
Switching on the ventilation system
If the ventilation system cannot be switched on, make
sure that the metal grease filter is correctly inserted.
1. Touch the : symbol.
The ventilation system will start at fan setting ƒ. The
fan setting that is selected will be displayed.
Notes
– Heat settings cannot be changed while the
setting is being applied for the ventilation system.
– During a period of a few seconds, a fan setting
for the ventilation system can be selected. The
setting area can then be used for selecting the
heat settings again.
2. Select the required setting from the setting area.
The setting that is selected will be displayed.
3. To set a different setting, touch the : symbol and
select the required setting from the setting area.
The setting that is selected will be displayed.
Switching off the ventilation system
If you want to switch off the appliance, touch the
# symbol. If you only want to switch off the ventilation
system, proceed as follows:
1. Touch the : symbol.
2. Select the ‹ symbol in the settings area.
3. Touch the : symbol to switch to the setting area for
the hob.
Note: The run-on will start once the appliance has been
switched off (depending on the basic settings selected).
To Next Page
Loading...
Need help?
General
