en Basic settings
22
To access the basic settings:
The hob must be off.
1. Switch on the hob.
2. Within ten seconds, touch and hold the 0 symbol
for approximately four seconds.
The first four displays provide product information.
Touch the settings area to view the individual
displays.
3. Touching the 0 symbol again takes you to the basic
settings.
™ and ‚ flash alternately on the displays and ‹
appears as a presetting.
4. Touch the 0 symbol repeatedly until the required
function is displayed.
5. Then select the required setting from the settings
area.
6. Touch the 0 symbol for at least four seconds.
The settings have been saved.
Leaving the basic settings
Turn off the hob with the main switch.
™‚ˆ
Configuring air recirculation mode or air extraction mode
‹ Air recirculation mode has been set.*
‚ Air extraction mode has been set.
™‚‰
Configuring automatic start
‹ Switched off.
‚ Switched on: The ventilation system starts at a specified power level.*
™ƒ‹
Configuring the run-on
‹ Switched off.
‚ Switched on: The ventilation system runs in air extraction mode for approx. 6 minutes at power level „ and in air recirculation
mode for approx. 30 minutes at power level ‚, and automatically switches off once this time has elapsed.*
™‹
Restoring the factory settings
‹ Custom settings.*
‚ Restore the factory settings.
Indicator/
symbol
Function
* Factory settings
**The hob's maximum power is shown on the rating plate.
Product information Display screen
After-sales service index (ASSI)
‹‚
Production number
”š
Production number 1
Š†.
Production number 2
‹.†
To Next Page
Loading...
Need help?
General
