Bosch PXX875D67E - Page 23

Basic settings en
23
Display Setting Value
⁠ Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob (see rating plate). If the function is active
and the hob has reached the set power limit,
is displayed and you cannot select a higher
power level.
– Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
⁠. - 1500 W.
...
- 3000 W. Recommended for 13 A
⁠. - 3500 W. Recommended for 16 A.
- 4000 W.
⁠. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
⁠ MoveMode
Allows you to change the preset power levels
for the three cooking areas of the flexible
cooking zone.
Select one of the two cooking zones, set the
required power level in the settings area and
touch to confirm the new power level and
select the next cooking zone.
- Preset power level for the front cooking zone.
- Preset power level for the middle cooking zone.
⁠. - Preset power level for the rear cooking zone.
⁠ ⁠ Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
⁠ FlexInduction
Change the switch-on mode for the Flex
Zone.
- As two independent cooking zones.
1
- As a connected cooking zone.
⁠ Connect the wireless cooking sensor to the
hob.
- Connected correctly.
- Not connected correctly due to a transmission error.
- Not connected correctly due to a cooking sensor
fault.
⁠ Set circulating-air mode or air extraction
mode.
- Configure circulating-air mode.
1
- Configure air extraction mode.
⁠ Setting automatic start - Switched off.
- Switched on: Automatic mode with sensor control.
1
- Switched on: The ventilation system starts at a power
level in accordance with the relevant power levels for the
cooking zones.
⁠ Setting the sensor sensitivity for the ventila-
tion system.
- Lowest sensor sensitivity setting.
- Medium sensor sensitivity setting.
1
- Highest sensor sensitivity setting.
⁠ Setting the run-on
If your hob is working in air extraction mode,
the ventilation system is switched on at the
power level for approx. 6 minutes.
If your hob is working in circulating-air mode,
the ventilation system is switched on at the
power level for approx. 30 minutes.
The run-on function automatically switches
off after this time.
- Switched off.
Switched on: Automatic function with sensor-controlled
run-on.
- Switched on
1
:
⁠ Automatic cookware detection - Manually select the required cooking zone.
- The cooking zone detects the size and the position of
the cookware and selects the corresponding cooking
zone(s).
1
⁠ Restoring factory settings - Individual settings
1
.
- Factory settings.
1
Factory setting
22.2 To go to the basic settings
Requirement:The hob must be switched off.
1.
To switch on the hob, touch ⁠.
2.
Within the next 10 seconds, press and hold for 4
seconds.
Product information Display
Directory for the technical after-sales
service (TK)
⁠
Production number