Bosch PXX875D67E - Page 25

HomeConnect en
25
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the HomeCon-
nect app.
→"Safety", Page2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the HomeConnect
app.
¡ In networked standby mode, the appliance requires
a maximum of2W.
¡ Hobs are not designed to be left unattended. Al-
ways monitor the cooking process.
25.1 Setting up the HomeConnect app
1.
Install the HomeConnect app on your mobile
device.
2.
Start the HomeConnect app and set up access for
HomeConnect.
The HomeConnect app guides you through the en-
tire login process.
25.2 Setting up HomeConnect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The HomeConnectapp has been installed on your
mobile device.
¡ The appliance is receiving signals from the WLAN
home network (Wi-Fi) at its installation location.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
1.
Open the HomeConnect app and scan the follow-
ing QR code.
2.
Follow the instructions in the HomeConnect app.
25.3 Overview of the HomeConnect settings
You can adjust the settings and network settings for HomeConnect by going to your hob's basic settings.
Setting Selection or display Additional information
⁠ ⁠ Network connection
– Not connected/disconnect network
– Connect automatically
– Connect manually
– Connected
Log on the hob in the Wi-Fi home network (Wi-Fi) or dis-
connect from the network
⁠ ⁠ Connection to app
– Not connected
– Connect
⁠ is only displayed if the hob is connected to the
home network.
⁠ ⁠ Connection to the Wi-Fi
– Wireless module switched off
– Wireless module switched on
If Wi-Fi has been activated, you can use the HomeCon-
nect functions.
⁠ is only displayed if the hob has been previously
connected to a network.
⁠ ⁠ Set using the app
– Switched off
– Switched on
1
If ⁠ is switched off, only the hob's operating statuses
are displayed in the HomeConnect app.
⁠ ⁠ Software update
– Update available and ready to in-
stall
– Start installation
⁠ is only displayed if a software update is available.
⁠ ⁠ Controlling remote access by after-
sales service
– Not authorised
– Authorised
⁠ is only displayed if after-sales service is attempting
to connect to the hob. After granting access, you can ter-
minate this at any time.
1
Factory setting