Bosch PXX875D67E - Page 29

FAQs en
29
Cleaning the grease filter in the dishwasher
1.
For optimum cleaning results, disassemble the
grease filter.
2.
Place the individual components of the grease filter
loosely in the dishwasher and do not jam them in.
Do not clean heavily soiled grease filters with table-
ware.
Do not use aggressive, acidic or alkaline cleaning
products.
3.
Start the dishwasher.
Select a maximum temperature setting of 70°C.
4.
Leave the grease filter to drain.
26.7 Cleaning the overflow container
The overflow container collects liquids or objects that
come into the appliance from above.
Requirement:The appliance has cooled and the resid-
ual heat indicator has gone out.
1.
Hold the overflow container with one hand and un-
screw it with the other hand.
‒ Hold the overflow container level to prevent liquid
from leaking out.
2.
Empty the overflow container and rinse it out.
3.
If required, unscrew the screw and clean the over-
flow container without the screw in the dishwasher.
4.
Clean the overflow container before screwing it
back into place.
5.
Ensure that the supply to the overflow container is
not blocked.
Remove any objects that have entered the appli-
ance once it has cooled down. To do this, remove
the grease filter. →Page28
FAQs
27 FAQs
27.1 Using theappliance
Question Answer
Why can I not switch on the
hob and why is the Child-
proof lockdisplay lit?
¡ The Childproof lock function is switched on. You can find further information about
this function under
→"Childproof lock", Page21.
Why are the illuminated dis-
plays flashing and why is a
signal sounding?
¡ Clean the surface of the control panel of any liquids or food residue. Remove any
objects that may cover the control panel.
You can find further information about deactivating the signal tone under
→"Basic settings", Page22.
Why can I not activate the
cooking assistance func-
tions?
¡ The appliance has exceeded its maximum power consumption or the Power limit-
ation function has been switched on. Switch off or reduce the power levels of the
active hotplates.
You can find further information about this function under
→"Power limitation", Page24.
The ventilation system does
not switch on even though
the automatic start is activ-
ated.
¡ Manually activate the ventilation system or check the configuration of the auto-
matic start. You can find additional information about this in the section entitled
→"Basic settings", Page22.