Bosch PXX875D67E - Page 33

Disposal en
33
Fault Cause and troubleshooting
The connection to the cooking sensor has been broken.
▶
Switch off the function and reactivate it.
The cooking sensor is broken/faulty.
▶
Contact the technical after-sales service.
The wireless cooking
sensor display does
not light up.
The wireless cooking sensor is not responding and the display does not light up.
▶
Replace the 3 V CR2032 battery. For more information, see the section entitled
→"Replacing the battery", Page20.
▶
If this does not solve the problem, press and hold the symbol on the cooking sensor for
8–10 seconds and then reconnect the cooking sensor to the hob. For more information,
see the section entitled
→"Connecting the wireless cooking sensor", Page19.
▶
If the problem persists, contact our technical after-sales service.
The display on the
sensor flashes twice.
The battery in the cooking sensor is almost flat. The next time you cook, you may be inter-
rupted by the battery running out.
▶
Replace the 3 V CR2032 battery. For more information, see the section entitled
→"Replacing the battery", Page20.
The display on the
sensor flashes three
times.
The connection to the cooking sensor has been broken.
▶
Press and hold the symbol on the cooking sensor for 8–10 seconds and then reconnect
the cooking sensor to the hob. For more information, see the section entitled
→"Connecting the wireless cooking sensor", Page19.
/ The operating voltage is incorrect and outside of the normal operating range.
▶
Contact your energy supplier.
/ The hob is not connected correctly.
▶
Disconnect the hob from the mains. Connect the hob in accordance with the circuit dia-
gram.
Demo mode is activated.
▶
Disconnect the hob from the mains. Wait for 30 seconds and connect the hob. Touch
any sensor in the next threeminutes. Demo mode is deactivated.
HomeConnect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
28.3 Normal noises from your appliance
An induction hob may sometimes cause noises or vi-
brations, such as buzzing, crackling, hissing noises, fan
noises or rhythmic noises.
Disposal
29 Disposal
29.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Declaration of Conformity
30 Declaration of Conformity
BSH Hausgeräte GmbH hereby declares that the appli-
ance with Home Connect functionality conforms to the
basic requirements and other relevant provisions of Dir-
ective 2014/53/EU.