32 | English
F 016 L70 576 | (14.11.08) Bosch Power Tools
Machine leaves ragged finish
and/or
Motor labours
Height of cut too low Increase height of cut (see “Ad-
justing the Cutting Height”)
Cutting blade dull Replacing the blade (see
“Blade Maintenance”)
Possible clogging Check underneath the machine
and clear out as necessary (al-
ways wear gardening gloves)
Blade fitted upside down Refit blade correctly (see
“Blade Maintenance”)
Area of cut (battery duration)
not large enough
Height of cut too low Increase height of cut and walk
slower
Grass too high Increase height of cut and walk
slower
Grass wet or damp Wait until grass is dry and walk
slower
Grass is dense Increase height of cut, walk
slower and cut more frequently
An additional battery can be
purchased from an authorised
customer service agent for
Bosch garden products
Contact Service Agent
Cutting blade not rotating while
machine switched on
Cutting blade obstructed Switch off machine
Clear obstruction (always wear
gardening gloves)
Blade nut/bolt loose Tighten blade nut/boltn
Excessive vibrations/noise Blade nut/bolt loose Tighten blade nut/boltn
Cutting blade damaged Replacing the blade
No charging procedure possible Battery contacts contaminated Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or re-
place the battery
The battery is defective, due to
a disconnection in the battery
(individual cells)
Replace the battery
The charge control LEDs 18 and
19 respectively, do not light up
after inserting the mains plug
into the socket
Mains plug of battery charger
not plugged in (properly)
Insert mains plug (fully) into
the socket outlet
Socket outlet, mains cable or
battery charger defective
Check the mains voltage and if
necessary, have the battery
charger checked by an author-
ized customer service station
for Bosch power tools
Problem Possible Cause Corrective Action
OBJ_BUCH-882-001.book Page 32 Friday, November 14, 2008 7:42 AM
To Next Page
Loading...
