Basic Operation en-us
31
Basic Operation
13 Basic Operation
Basic Operation
13.1 Protection against
unintentional
operation
Your dishwasher has a built in
feature to help prevent uninten-
tional operation, e.g. by children.
After starting the appliance, the
door has to be closed within 4
seconds, otherwise the operation
will be paused. If this occurs, fol-
low the steps below to restart your
dishwasher.
1. For top button controls: Press
and close the door.
2. For front button controls: Close
the door and press .
a The wash cycle will resume.
Notes
¡ Unintentional operation is
activated when:
– Pressing Start to begin a
wash cycle
– Setting Delay time and
pressing Start
– Opening the door while De-
lay time is active
– Opening the door during a
wash cycle.
¡ This feature cannot be deacti-
vated.
13.2 Switching on the
appliance
▶ Touch with a short 1
second touch.
The cycle last selected and the
option last selected will be set
by default.
The buttons on the appliance
are touch sensitive and only re-
quire a quick, gentle touch.
If you do not perform any ac-
tions on the appliance for 10
minutes, it will automatically
switch off.
13.3 Setting a cycle
To adjust the wash cycle to the
soiling level of the dishware, se-
lect a suitable program.
▶ Press the right cycle button.
a The cycle is set and the cycle
button flashes.
a The remaining run time of the
cycle appears on the display.
13.4 Setting options
You can set options to complete
the chosen wash program.
Note:The available options de-
pend on which program is se-
lected.
▶ Press the button for the rele-
vant option.
a The option is set and the option
button flashes.
13.5 Setting the electronic
delay time
You can delay the start of the
wash cycle by up to 24hours.
1. Press .
a "h:01" appears on the display.
2. Use to set the required
start time for the wash cycle.
3. Press .
a This activates the electronic de-
lay time.
Tip:To deactivate the electronic
delay time, press repeatedly
until "h:00" appears on the dis-
play.
To Next Page
Loading...
