Bosch SGV78C53UC - Managing Wash Cycles

en-us Basic Operation
32
13.6 Starting the wash
cycle
▶ Press .
a The wash cycle has ended
when the display shows
"0h:00m".
Notes
¡ If you want to add more dish-
ware while the appliance is run-
ning, do not use the collecting
tray as a handle for the upper
rack. You might touch the par-
tially dissolved tablet.
¡ You can only change a cycle in
progress if you can cancel it
first.
→ "Terminating the wash cy-
cle", Page32
¡ To save energy, the appliance
switches off automatically
10minutes after the end of the
wash cycle. If you open the ap-
pliance door immediately after
the wash cycle has ended, the
appliance will switch off after 4
seconds.
13.7 Interrupting the wash
cycle
1. Press On/Off.
The program is saved and the
appliance switches off.
2. Press On/Off.
3. Press to resume the wash
cycle.
13.8 Terminating the
wash cycle
To end a cycle early or to switch
from one that has already started,
you will need to cancel it first.
1. Open the appliance door.
2. Press for approx.
4seconds.
3. Close the appliance door.
a The cycle is cancelled and
ends after approx. 1minute.
13.9 Switching off the
appliance
CAUTION
To avoid risk of injury, always use
caution when opening the door
during or following a wash cycle
as hot water or steam may es-
cape.
▶ Do not fully open the door until
water noises have stopped and
steam has subsided.
1. Please note the information on
Preventing Material Damage
→ Page9 .
2. Press On/Off.