Bosch SHE41CM5N - 14.1 Setting up the Home Connect app; 14.2 Setting up Home Connect; 14.3 Home Connect settings; 14.4 Remote Start

en-us HomeConnect®
20
To be able to use HomeConnect®, you must first set up
the connection to the WLAN home network (Wi-Fi
1
) and to
the HomeConnect® app.
The HomeConnect® app guides you through the entire
registration process. Follow the instructions in the
HomeConnect® app to implement the settings.
Tip:Follow the instructions in the HomeConnect® app as
well.
Note:Also note the safety information in this instruction
manual and ensure that it is also observed when operating
the appliance using the HomeConnect® app.
14.1 Setting up the HomeConnect® app
1. Install the HomeConnect® app on your mobile device.
2. Start the HomeConnect® app and set up access for
HomeConnect®.
The HomeConnect® app guides you through the entire
registration process.
14.2 Setting upHomeConnect®
Requirements
¡ The HomeConnect®app is installed on your mobile
device.
¡ The appliance receives signals from the WLAN home
network (Wi-Fi) at its installation location.
¡ The appliance door is closed.
1. Open the HomeConnect® app and scan the following
QR code.
2. Follow the instructions in the HomeConnect® app.
14.3 HomeConnect® settings
Adapt HomeConnect® to your needs.
You can find the HomeConnect® settings in the basic
settings for your appliance. Which settings the display
shows will depend on whether HomeConnect® has been
set up and whether the appliance is connected to your
home network.
14.4 Remote Start
You can use the HomeConnect® app to start the
appliance with your mobile device.
Note:You can change settings using the HomeConnect®
app.
Activating Remote Start
Requirements
¡ The appliance is connected to your WLAN home
network.
¡ The appliance is connected to the HomeConnect® app.
¡ A program is selected.
▶ Press ⁠.
If you open the appliance door, the function is
automatically deactivated.
a button lights up.
Tip:To deactivate the function, press ⁠.
Note
The following settings are possible using the
HomeConnect® app:
¡ Deactivate the function permanently.
¡ Select the function using the button. This setting is
the default preset at the factory.
¡ Activate the function permanently. With this setting
pressing button is not necessary.
14.5 Remote Diagnostics
The Customer Service can access your appliance via
Remote Diagnostics if you ask them to do so, if your
appliance is connected to the HomeConnect® server and
if Remote Diagnostics is available in the country where
you are using the appliance.
Tip:Further information and details about the availability
of Remote Diagnostics in your country can be found in the
Service/Support section of your local website: www.home-
connect.com.
14.6 Software update
You can use this function to update the software of your
appliance, e.g. for optimization, troubleshooting or safety-
relevant updates.
The HomeConnect® app informs you about available
software updates.
14.7 Data Protection
See the information on data protection.
The first time your appliance is registered on a home
network connected to the Internet, your appliance
transmits the following types of data to the
HomeConnect® server (initial registration):
¡ Unique appliance identification (consisting of appliance
codes as well as the MAC address of the installed Wi-Fi
communication module).
1
Wi-Fi is a registered trade mark of the Wi-Fi Alliance.