EasyManua.ls Logo

Bosch SHU3305 - To Raise Right Side of Tank for Apexx Module Access

Bosch SHU3305
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
VI.
VI.
Component Access/Replacement
Component Access/Replacement
Control Modules
Control Modules
Apexx
Apexx
Control Module Disassembly (3)
Control Module Disassembly (3)
To raise right side of tank for Apexx module access (where
necessary):
Remove one T-20 Torx screw from both rear corners holding tank to
base (1) -- removing screw from both sides allows tank to be blocked
upward.
Remove right toe kick bracket by removing T-20 Torx screw (2).
Remove T-20 Torx screws from front right bottom corner holding tank to
base (3).
Remove right hinge cover (4a), release right door tension cord from
hinge (4b) & remove ground wire (4c).
Raise and block up tank as shown with strut onto base (5a), sliding a
piece of wood or other solid material between the tank and base to keep
tank from falling back onto base (5b).
Screw
21
4a
5b
5a
3
4c
4b
CAUTION: Its not recommended to turn dishwashers
upside-down for tank access. When dishwashers are turned
upside-down, water can flow into the diaphragm of the water
fill assembly and cause water to not fill properly.

Table of Contents

Other manuals for Bosch SHU3305

Related product manuals