Troubleshooting en-us
53
Issue Cause and troubleshooting
Appliance cannot be
switched on or oper-
ated.
4. Switch the appliance on.
Appliance does not
start.
The breaker has tripped.
▶ Check the relevant breaker.
Power cord is not inserted.
1. Check whether the power outlet is working.
2. Check whether the power cord plug is properly
inserted in the power outlet and on the rear of
the appliance.
Appliance door is not closed properly.
▶ Close the appliance door.
Wash cycle starts
up automatically.
You did not wait until the cycle ended.
▶
→
"Terminating the wash cycle", Page33
Appliance stops dur-
ing the cycle or cuts
out.
Appliance door is not closed properly.
▶ Close the appliance door.
Power and/or water supply has been interrupted.
1. Check the power supply.
2. Check the water supply.
Upper rack is pressing against inner door and
preventing appliance door from being closed se-
curely.
▶ Check whether the rear panel of the appliance
is being pressed in by a power outlet or a hose
holder that has not been removed.
▶ Arrange the dishware so that no parts project
beyond the rack and prevent the appliance
door from closing properly.
Appliance door can-
not be closed.
Door lock has been activated.
▶ Close the appliance door with greater force.
Door cannot be closed due to installation method.
▶ Check whether the appliance has been in-
stalled properly.
When closed, the appliance door, its decor or
attached parts should not knock against adja-
cent cabinets or the worktop.
Lid on the detergent
dispenser cannot be
closed.
Detergent dispenser or lid are blocked by sticky
detergent residue.
▶ Remove detergent residue.
Filling valves mak-
ing knocking noises.
Caused by the domestic installation. No fault
present in the appliance. Does not affect function-
ing of the appliance.
▶ Can only be remedied in the home installation.
To Next Page
Loading...
Need help?
General
